 |
|
 |
|
|
|
 |
 |
| |
To answer the growing demand for a Roman or folding blind
system to suit both internal and external applications in all
aspects and infinite shapes and sizes, REFLEX™ has developed
the TROJAN™ K100 family of product into the already extensive
range of REFLEX™ automated, environmental control blinds and
screens.
|
|
 |
| |
The area to be covered by a TROJAN™ system can be square,
rectangular or trapezium in shape and can be in any aspect from
horizontal to vertical. The mounting of the system can be interfaced
at any location along the two parallel end rails to coincide with
substructure. The minimum tension within the system is transferred
through either these side rails or secondary suspension cables. All
system hardware and the drive system should be mounted onto
the end rails and minor alignment discrepancies can be overcome
with built in adjustment.
|
|
|
 |
| |
The basic system operates using the traditional Roman blind or
folding fabric principal, where the fabric is suspended by battens
and traverses along special side drive guides or suspension
cables. As the fabric has little tension exerted upon it (other than
gravity) the size and shape limitations are more relaxed than in
other applications where the fabric is pulled taught by motors or
spring tension.
The fabric is attached to the system via light weight 40 x 25 mm
aluminium cross rails with a unique polymer spline which both
locates the fabric and secures it in position, as well as allowing for
easy fabric element replacement at any time, without disturbing
the rest of the installation and drive system.
Fabrics that can be used in this system are many and varied due
to the low tension exerted upon the textile in use. The TROJAN™
system lends itself perfectly to horticultural (greenhouse) use
where light control and air circulation are critical as some fabrics
utilise ventilated weaves and therefore have a very low structural
strength.
The drive system is incorporated within the mounting rail and
uses the electronic tubular motor within a 60 mm aluminium drive
tube.
To the drive tube are affixed two adjustable toothed drive belts,
which in turn drive gearboxes to transfer the drive effort to the
transport belt within the parallel side rails. The main leading batten
and subsequent battens are then extended in turn, by the pulling
of the fabric element itself from the leading edge.
The mounting rail is 50 mm x 100 mm “C” section aluminium,
powder coated to suit, and can be mounted at any aspect with the
provided fixings through the rail at variable points.
The system can be installed as a square, rectangle or trapezium
and in some cases multiple systems can be adjoined at the motor
end in tandem to cover areas up to 60 square metres. Trapezium
shapes will travel from the wider end to close at the narrower end
with the travel of rectangular systems to be top down or bottom
up configurations.
Minimum width = 1,500 mm
Maximum width = 6,000 mm
Minimum projection = 1,000 mm
Maximum projection = 5,000 mm
|
|
|
 |
 |
|
|
| |
|
|
|
|
|
